Uno R3 Board without Cable compatible with Arduino

Arduino Uno R3 is one of the widely used and accepted module for prototyping. It has huge user community worldwide. Uno R3 SMD module is based on the Atmega328p-AU MCU of Atmel AVR Family. It is a 8 Bit Microcontroller. This is an entry level development board. But, is not a basic one, it packs 32 KB Flash, 2 KB RAM, and 1 KB of EEPROM.

The module has onboard USB to TTL converter chip. It also has onboard voltage regulator for 5V and 3.3V. The module can take input of up to 16V DC. The module has a 16 Mhz clock. The Atmega needs 5V for operation @ 16 Mhz. It has 14 Digital I/Os, and 6 Analog Inputs. Out of 14 Digital I/Os, 6 pins can provide PWM output. The module has a UART on pins 0 and 1. Almost all of the pins are mappable with interrupt vector.

The max DC Current per I/O pin is 20mA. The analog inputs can also function as digital I/Os. It supports various interfaces like: SPI,I2C, UART, etc. Also, the onboard 3.3V pin can provide upto 50mA current.

It is used for quick prototyping. This version comes with Separate header pins, which are solderable if required, for connection of female jumper wires.

The module is easily programmable using the Arduino IDE on PC. It needs to connect to the PC via USB Cable. So, the IDE will detect it, and on click of a button, the program compilation and uploading to the development Board will be done. The module can be also programmed via dedicated pins for the programmer, but the Atmel ICE or similar compatible programmer is required in that case. Whereas, No extra components are required, in case of USB.

The IDE provides various ready to use libraries, increasing the usage scenarios for the board.
Note: The Uno R3 reference design can use an Atmega8, 168, or 328, Current models use an ATmega328, but an Atmega8 is shown in the schematic for reference. The pin configuration is identical on all three processors.

Features :

1. 1.0 pinout: added SDA and SCL pins that are near the AREF pin and two other new pins placed near the RESET pin, the IOREF, that allow the shields to adapt to the voltage provided by the board. In the future, shields will be compatible with both the board that uses the AVR, which operates with 5V, and the Arduino Due, which operates with 3.3V. The second one is a not-connected pin; that is the reserve for future purposes.
2. Stronger RESET circuit.
3. Atmega 16U2 replaces the 8U2.

Package Includes :

1 x Uno R3 Board without Cable compatible with Arduino

Useful Links:
Getting Started with Arduino and Genuino products